Well the designs are finalised and approved.The following are all of the pieces that I'll be making.
First The Altar. It will be 72" wide x 36" deep x 39" High. I'll turn the chalise and host. This will take a little over 40 bd. ft. of Oak.
Second piece is the Ambo. 50" Hx 24" W x 23" Deep. This will be 25 bd ft of oak.
third the chairs the big one is 50" tall and the smaller one is 40" tall. about 18 Bd.ft.
Side table one will go between the chairs 24"x24"x 18" h. 7 bd.ft.
Table 2 will be 32"w x 24" d x 26" h. 10 Bd. ft.
Ambrie will be 32" h x 20" w x 16" Deep and about 14 bd.ft.
Here is an overall picture the cross will be hollow 10 ft. Hi by 5 ft across and 8". It will be hollow and made of 8/4 oak. It will take about 28 bd.ft of oak.
All told I'll be using about 150 Bd. Ft of Oak for this project. I'll built the smaller pieces first due to a lack of room and the bigger pieces last. I don't have enough room to store all the pieces so I'll hold off on the big stuff until the church building is at a stage where I can store them there safely. I'll start this build on October since I need o get all of the other work out of my shop so I have room for this project.
I want to thank everyone here for there help and I'll post progress pictures of the project when I do each part.