glenn bradley
Member
- Messages
- 11,568
- Location
- SoCal
While moving things about I came across a jig accessory that I had cut out but never put together. Took a short break from schlepping lumber to finish this thing off. I had to cut the dovetails in the face plate.
The intention is to grip things to the face plate and be able to safely move them through operations. I added a couple of slots so it can also be attached to the new sled although that is not the main use.
By its nature it could be used as a tenoning jig. I have a cast iron tenon jig that I prefer.
However, my cast iron one will not allow me to make angled tenon cuts
Or even more unusual cuts.
I designed it with the intention of using it at the tablesaw, router table, drill press, and edge sander.
The intention is to grip things to the face plate and be able to safely move them through operations. I added a couple of slots so it can also be attached to the new sled although that is not the main use.
By its nature it could be used as a tenoning jig. I have a cast iron tenon jig that I prefer.
However, my cast iron one will not allow me to make angled tenon cuts
Or even more unusual cuts.
I designed it with the intention of using it at the tablesaw, router table, drill press, and edge sander.