- Messages
- 16,600
- Location
- Reno NV
I made this 'cutting' board a while ago but really never used it much. It's a little narrow, but lately I've been getting into baking more, making pizzas on fridays and doing an occasional pie or some buns or whatever.
Thought I would decorate it up with some useful laser markings. Well, Found out the stepper driver I had on the Z axis was a little wonky. It had some cold solder joints. I soldered them back up and it worked for about 10 minutes, so just punted and ordered a new one. Got the part in, set the dip switches and fired up my lightburn project. Looking forward to pizza night now to see how round I can make them!
Thought I would decorate it up with some useful laser markings. Well, Found out the stepper driver I had on the Z axis was a little wonky. It had some cold solder joints. I soldered them back up and it worked for about 10 minutes, so just punted and ordered a new one. Got the part in, set the dip switches and fired up my lightburn project. Looking forward to pizza night now to see how round I can make them!
